Shawn has successfully modified a Denon 2900 with the PMS SDI mod. kit. Congratulations!

"I mapped out the 8 input pins on the Sil504 to the ribbon cable feeding the video board.

Pin 1 was ground
Pin 2 = data2
Pin 3 = data3
et...etc.. up to pin 9.

Pin 13 was the clock and I took power over at the power supply connector to the video board. Also I used different wires to connect into the video board as the PMS supplied wires were too fat to fit through the holes in the board.

No need for a noise filter on the clock line on my setup. It synced right up to a CS-2 w/SDI and had a very clean picture."

Before the mod:

This is the deinterlacer board:

 Solder the data/clock wires on the ribbon cable connector:

Closeup:

Zoom in:

Then the SDI mod. kit was mounted:

Power cable:

The rear view:

Well done!